Its not enough to declare "doc" as DynamicJsonPSRAMDocument - PSRAM is not yet initialized when "doc" is created. So we need a trick to get the main doc into PSRAM later, during WLED::setup().
Code is very experimental, may or may not work, and need more testing
-> disabled with "#if 0"
According to the technical manual, GPIO 16 + 17 are used for onboard flash, so cannot be used by WLED.
example buildenv:
[env:esp32_pico]
extends = env:esp32dev_qio80
board = pico32
we can use `-D CONFIG_ASYNC_TCP_TASK_STACK_SIZE=xxxx` to increase the stack size of AsyncWebserver - default is 8196.
This should give us a bit of headroom for new UI items.
We still need PR #94 for more savings.
* Initial checkin for ESP-NOW remote feature
* cleanup irrelevant comment
* don't bring in espnow package includes when feature disabled
* Formatting and removing inaccurate call mode hardcoding
* Fork ESP Now code by platform (8266 v. esp32)
* compiled html update
* Disable ESP-NOW remote by default on ESP32 until tested
* Enable ESP-NOW remote for ESP32
* Rename ESP NOW define
---------
Co-authored-by: cschwinne <dev.aircoookie@gmail.com>
* it seems that NPB is very sensitive when being interrupted during LEDs driving. This change tries to avoid flash (file) writes when the strip is active.
* minor optimization: yield is completely unnecessary on ESP32 (we have a real OS).
This disables parts of the new feature that might lead to delays, so basicially there is some detection, but no protection any more.
further development needed --> audio_fastpath branch
compile with -D WLEDMM_PROTECT_SERVICE to enable full protection.
*This patch allows to compile with BOARD_HAS_PSRAM, but not set WLED_USE_PSRAM - reserved pins will be protected, and PSRAM usage will be shown in info.
* if you add `-D WLED_USE_PSRAM_JSON` then PSRAM will be used for some JSON buffers, but not for LEDs and Segments.
* pio.ini: add "-Wshadow=compatible-local" for V4 targets
* pio.ini: fix alignment for 8266 build_flags
* fix one (harmless) case of shadowed vars in MM specific code
... like the typical -C3
* Replaced a few direct Serial.printf with macros
* Always check if Serial is connected before printing (CDC sometimes hangs when trying to send/receive without connection)
* Info page: status of Serial (can be disconnected on new MCUs), and owner of RX/TX pins
* improved handling of Serial (don't write if not connected)
* added min available stack size to debug output (esp32 only)
* webserver show remaining stack size
* webserver: show string buffer usage
