buildenv improvement for -C3

* IRremoteESP8266 @ ~2.8.2
* -D WLED_DISABLE_ADALIGHT (as most devices don't have a serial-to-USB chip)

platformio.ini

@@ -326,8 +326,10 @@ build_flags = -g
   ;; ARDUINO_USB_CDC_ON_BOOT
 
 lib_deps =
-  ${env.lib_deps}
   makuna/NeoPixelBus @ 2.7.3 ;; WLEDMM - new version is more stable on -C3
+  fastled/FastLED @ 3.5.0
+  IRremoteESP8266 @ ~2.8.2
+  https://github.com/Aircoookie/ESPAsyncWebServer.git @ ~2.0.7
   https://github.com/pbolduc/AsyncTCP.git @ 1.2.0
 
 [esp32s3]
@@ -1498,7 +1500,7 @@ build_flags = ${common.build_flags} ${esp32c3.build_flags}
   -D WLED_RELEASE_NAME=esp32c3dev_4MB_M
   ; -D WLED_DISABLE_BROWNOUT_DET
   ; -DARDUINO_USB_CDC_ON_BOOT=1  ;; enable CDC USB -> needed for debugging over serial USB
-  ; -D WLED_DISABLE_ADALIGHT     ;; to disable serial protocols when using CDC USB (Serial RX will receive junk commands, unless its pulled down by resistor)
+  -D WLED_DISABLE_ADALIGHT     ;; to disable serial protocols for boards with CDC USB (Serial RX will receive junk commands, unless its pulled down by resistor)
   -DARDUINO_USB_CDC_ON_BOOT=0    ;; disable CDC USB
   -D SERVERNAME='"WLED-C3"'
   ;-D WLEDMM_WIFI_POWERON_HACK ;; use this _only_ if your device is not able to make a WiFI connection!
@@ -1507,8 +1509,7 @@ build_flags = ${common.build_flags} ${esp32c3.build_flags}
   -D LEDPIN=8 ;; onboard neopixel 5x5 Matrix. Attach your own LEDs to GPIO 20
   -D BTNPIN=9
   ; -D STATUSLED=10 ;; onboard LED
-  ;-D RLYPIN=3
-  ;-D IRPIN=2
+  -D RLYPIN=-1 -D IRPIN=-1
   ;-D HW_PIN_SDA=0 -D HW_PIN_SCL=1 ;; for I2C Qwiic connector
   -D SR_DMTYPE=1 -D I2S_SDPIN=5 -D I2S_WSPIN=6 -D I2S_CKPIN=4 -D MCLK_PIN=7
   ; -D WLED_USE_MY_CONFIG