## Sync setup

### WLED Broadcast

UDP Port:
2nd Port:

### Sync groups

| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8
Send: |  |  |  |  |  |  |  |
Receive: |  |  |  |  |  |  |  |

Receive: Brightness, Color, and Effects
Segment options, bounds
Send notifications on direct change:
Send notifications on button press or IR:
Send Alexa notifications:
Send Philips Hue change notifications:
Send Macro notifications:
UDP packet retransmissions:
Reboot required to apply changes.

### Instance List

Enable instance list:
Make this instance discoverable:

### Realtime

Receive UDP realtime:
Use main segment only:
Network DMX input
Type:
Port:
Multicast:
Start universe:
Reboot required. Check out LedFx!
Skip out-of-sequence packets:
DMX start address:
DMX segment spacing:
E1.31 port priority:
DMX mode:
E1.31 info
Timeout: ms
Force max brightness:
Disable realtime gamma correction:
Realtime LED offset:
DMX Input Pins
DMX RX:
DMX TX:
DMX Enable:
This firmware build does not include DMX Input support.
This firmware build does not include DMX output support.

### Alexa Voice Assistant

This firmware build does not include Alexa support.
Emulate Alexa device:
Alexa invocation name:
Also emulate devices to call the first presets

⚠ MQTT and Hue sync all connect to external hosts!
This may impact the responsiveness of WLED.
For best results, only use one of these services at a time.
(alternatively, connect a second ESP to them and use the UDP sync)

### MQTT

This firmware build does not include MQTT support.
Enable MQTT:
Broker: Port:
The MQTT credentials are sent over an unsecured connection.
Never use the MQTT password for another service!
Username:
Password:
Client ID:
Device Topic:
Group Topic:
Publish on button press:
Retain brightness & color messages:
Reboot required to apply changes. MQTT info

### Philips Hue

This firmware build does not include Philips Hue support.
You can find the bridge IP and the light number in the 'About' section of the hue app.
Poll Hue light every ms:
Then, receive On/Off, Brightness, and Color
Hue Bridge IP:
. . .
Press the pushlink button on the bridge, after that save this page!
(when first connecting)
Hue status: Disabled in this build
This firmware build does not include Loxone Lighting support.

### Serial

This firmware build does not include Serial Command support.
Adalight/TPM2, Serial JSON, Improv, and serial streaming are not possible.
Baud rate:
Keep at 115200 to use Improv. Some boards may not support high rates.

### Net Print ☾

This firmware build does not include Net Print support.
Netcat host IP:
. . .
Netcat host Port:
If 0 default port 7868 will be used
on host [ip] open command prompt and enter

    nc -l [port] -u